33
IR Products
Xantech Corporation | 1969 Kellogg Avenue, Carlsbad, CA 92008 | 800.843.5465 | FAX 800.492.6832 | www.xantech.com
Designer IR Emitters
Minimum Requirement: IR Receiver, Connecting Block & Power Supply. Are compatible with all Xantech IR Systems
STANDARD DESIGNER EMITTERS
STANDARD HIGH OUTPUT DESIGNER EMITTER
• Non-visible, high-output version
• Deep purple Lexan™ shell
• Clear adhesive lm included on emitter housing for attachment to IR window of
controlled component
• Includes 3 pre-cut adhesive backings for replacement purposes
• Lead is terminated with a 3.5mm mono mini plug
• Length of wire: 10 feet
Order: 282D
DESIGNER EMITTER Value Pack
Save 5% On 5 Pack Order: 282D5P
Save 10% On 10 Pack Order: 282D10P
DESIGNER EMITTER With Twin Plug
• 282D high-output Designer Emitter with two 3.5mm plugs
• Allows control of single source by two IR systems
• Diode isolation for independent control and component protection
• Wire length: 10 feet
Order: 282TPD
‘NAKED’ EMITTER
282M high-output Emitter with no shell surrounding emitter head
• Allows insertion of emitter inside component case for the cleanest
appearance possible
• Wire length: 10 feet
Order: 282X
DUAL DESIGNER EMITTER
• Two emitters in series with each other and terminated in a single 3.5mm mono mini plug
• Length of wire: 7 feet to junction, 3 feet to each emitter
• Non-visible, high output version
Order: 284D
DUAL DESIGNER EMITTER Value Pack
Save 5% On 5 Pack Order: 284D5P
Save 10% On 10 Pack Order: 284D10P
Comentarios a estos manuales