31
IR Products
Xantech Corporation | 1969 Kellogg Avenue, Carlsbad, CA 92008 | 800.843.5465 | FAX 800.492.6832 | www.xantech.com
CONNECTING BLOCKS
TWO ZONE CONNECTING BLOCK
• Simpli ed version of the 795 controller when only two zones are required
• One plug-in screw connector for each zone’s IR receiver and/or keypads
• 3.5mm mono mini jack for zone and common IR emitters
• Can be used with a 791-44 ampli ed connecting block for
common emitter expansion
• Requires either the 781ERGPS or 782ERGPS Power Supply
• Only to be used with single or dual emitters on the zone outputs
• Dimensions: 3” x 1 3/4” x 13/16” (77mm x 45mm x 21mm)
Order: ZC21
“THE STRIP-IR” PARALLEL CONNECTING BLOCK
• Easily connects home run wires from multiple IR Receivers to the input
• High current design (12 Amps peak) allows ampli ers rated as high
as 500 Watts to be used with the CB18
• One-in/eight-out or eight-in one-out capability
• Nine four-terminal plug-in connectors on 4-conductor bus
• Screw terminals handle wire sizes from 24 to 12 gauge
• Dimensions: 111/4” x 1 1/4” x 1 1/4” (286mm x 32mm x 32mm)
Order: CB18
PHANTOM POWER MODULE FOR IR RECEIVERS
• Provides phantom power for standard Xantech IR receivers.
• High current mode drives 790 connecting block
• 3.5 mm mono mini jack emitter port.
• Requires the 781ERGPS Power Supply
• Dimensions: 41/4” x 1 5/8” x 1” (108mm x 42mm x 26mm)
Order: 79210
SERIAL CONTROL COMBINER
• Combines IR serial data from up to ve A/V receivers to common source equipment
• Isolating diode system prevents serial control interference between receivers
• DIP switch sets polarity for either positive or negative serial logic systems
• Can be “daisy chained” to accommodate any number of
A/V receivers in multi-zone systems
• Requires same brand components
• Used in multi-zone systems
• Dimensions: 6” x 2 1/4” x 1” (153mm x 58mm x 26mm)
Order: 79310
Comentarios a estos manuales